Wavlink N300 WiFi Repeater Setup – A 5-Step Guide
Installing a range extender in the house is considered a daunting task by many. However, it is not. The only thing a user needs to access is the web-based management panel of the device using a computer. After that, following the on-screen is recommended. In this post, we will try to make you understand the process to do Wavlink N300 WiFi repeater setup. Keep in mind that the instructions provided here can be implemented on any range extender brought in by Wavlink.
Wavlink N300 WiFi Repeater Setup [Modes]
Before proceeding further, we want to inform you about the different modes on which your N300 WiFi extender can operate. Having a little knowledge about them will help you decide the operating mode on which you should set up your range extender.
i) Repeater Mode
If you configure your N300 device into the repeater mode, you have the liberty to connect it to the host gateway using a wireless or wired source. After that, it will do the job of repeating the wireless signals emitted by the host gateway.
ii) Access Point Mode
When in the Access Point mode, the extender will act as a WiFi hotspot for various devices present in your house. But, you must connect the extender and host gateway using a cable in this case.
iii) Router Mode
This mode is of great assistance for those users who do not have WiFi routers in their homes and wish to set their repeaters with internet modems. The connection source suggested for Wavlink N300 WiFi repeater setup in this operating mode is a wired one.
Now that you’ve learned about various operating modes of your range extender, it is time to move to the instructions that will help you set up your WiFi device by accessing the Wavlink login portal.
Wavlink N300 WiFi Repeater Setup [Steps]
i) Choose the Operating Mode
Right after unboxing your N300 wireless repeater, you are required to connect it to a wall outlet near the main gateway and press the Power button. Consider waiting for LEDs to settle. After that, you need to toggle the Mode Selector button on the extender to the Repeater/ Access Point/ Router position depending upon your requirements.
ii) Connect Your Devices
The second step involved in the setup process is to create a connection between your host gateway and repeater. Therefore, put the suggested connection to use [as per the operating mode chosen by you]. But, you need to make sure that in case of a wireless connection, your devices must be close to each other. If you’ve connected them using a cable, the connection must be made using a non-damaged cable only.
iii) Run an Internet Browser
The moment you create a successful connection between your devices, you are suggested to switch on your computer and run an internet browser. You are free to put any web browser to use. However, remember to wipe out the cache and cookies before proceeding further with the Wavlink N300 WiFi repeater setup. Also, check for updates and install the latest software version of the web browser if available.
iv) Visit wifi.wavlink.com
Now, go to the URL field of the internet browser and type wifi.wavlink.com. Hitting the Enter key will take you to the admin portal of your N300 repeater. But, make sure that the web address entrée is done without mistakes. Else, you’ll end up landing on some other page instead of the login portal.
v) Input the Extender’s Password
On the admin page of your Wavlink N300 repeater, you need to select the preferred language and enter the default login password. FYI, the login password of your repeater is case-sensitive. Therefore, be very careful while entering it. As soon as you enter the password, hitting the Login button is recommended to enter the final stage of the setup process.
And, there you are, the Wavlink N300 WiFi repeater setup wizard will show up on the screen. There, you will come across a few instructions. Walk through them to complete the installation process. Once done, you are free to access the newly extended network in any nook and cranny of your house.